Carousel has a very high status in the amusement equipment. Therefore, many amusement equipment factories regard the characteristic carousel as the selling point. However, the popularity of carousel equipment is very high both indoors and outdoors. Therefore, the equipment has high operation frequency and fast wear speed. Therefore, investors are very distressed when there are some faults. Next, qiluodi entertainment editor will share with you This carousel amusement equipment common breakdown solution!

1、 The problem of not starting

1. Electric control cabinet and line fault

If it can not be started, first check whether the electric control cabinet is working. First, check whether the power indicator light of the electric control cabinet is on. If the indicator light is on, it means that the circuit connecting the power supply to the electric control cabinet is OK. If the indicator light is not on, first of all, check whether the circuit connecting the power supply to the electric control cabinet is broken or short circuited. If so, re connect or replace the circuit. If there is no problem, then open the electric control cabinet to check whether the switch knife of the relay is closed and whether the fuse is fused. If so, close and replace it.

If the fault still exists, check whether the circuit connecting the electric control cabinet to the carousel conductive ring is broken (the position of the conductive ring is at the carousel central pillar), and whether the line from the conductive ring to the motor is broken. If so, re connect or replace the line. Check the contact part of the conductive ring and carbon brush for dust and poor contact. If so, press it with a screwdriver for several times.

2. Motor failure

If there is no fault in the electric control cabinet and circuit, or the fault can not be started after troubleshooting, it is necessary to check whether there is a fault of the motor. Remove the belt from the belt pulley of the motor. The electric control cabinet starts the start button, and then check whether the motor is working. If not, the motor is damaged and needs to be replaced.

2、 Difficult to start

1. The bearing is too tight

This kind of failure usually occurs in the case of new carousel, which can be adjusted by wrench with moderate tightness. In addition, lubricating oil can be added for better effect.

2. Voltage unstable or too low

Many amusement equipment are difficult to start or can not start because of voltage instability or low, mainly due to the nearby voltage load is too large, this phenomenon is particularly obvious in summer. The way to check is to press the start button of the electric control cabinet and observe whether the voltmeter is normal.

The solution is to replace a larger square of the power cord or replace the line access point. The most direct but not effective way is to press the start button of the electric control cabinet, and then find two people to push the market to see if it can work normally.

3. Loose V-belt

If the V-belt is loose, you can adjust the distance between the motor and the pulley or replace it with a new one of the same model.

3、 Excessive jitter and noise

The problem of jitter and excessive noise is that one is caused by the unstable operation of the whole panel. You can check whether there is air leakage or insufficient air pressure of the tire. If the air leakage is found, it needs to be replaced or repaired. If the air pressure is not enough, the tire can be inflated. Generally, three and a half air pressures are enough. Second, because the friction force of the transmission part and bearing increases, lubricating oil can be added.