what are the power and space requirements for a motorbike arcade? | Insights by DINIBAO

Use the machine nameplate or supplier specification as the starting point for input voltage, frequency, rated power, and current. Do not size a circuit from cabinet appearance or monitor wattage alone: the drive system, audio, lighting, control electronics, and any motion hardware may contribute to the load. A qualified electrician should check the local code, circuit rating, protective devices, plug format, earthing, and expected simultaneous operation. For a multi-unit installation, add the specified loads, apply the venue's applicable demand rules, and confirm the result against measured startup and operating conditions.

There is no responsible universal clearance figure because motorcycle cabinets differ in bodywork, handlebar position, seat geometry, motion range, and service-panel location. Begin with the complete assembled footprint from the manufacturer, then add a clear player zone around the riding position and preserve access to rear, side, or front panels identified for maintenance. Keep emergency routes, exits, fire equipment, columns, and neighboring attractions unobstructed. A scaled floor plan and a physical or taped-out trial are more reliable than calculating from the base dimensions alone.

They may share a circuit only when the combined nameplate load, inrush behavior, protective-device rating, conductor capacity, socket arrangement, and local electrical rules support that arrangement. Operators should not assume that several low-looking standby loads remain harmless when motion motors, displays, or other systems start together. Separate circuits can simplify fault isolation and reduce disruption, but the decision belongs to a qualified electrician using the actual machine specifications and venue distribution board. Record which units share each circuit and label isolation points for service work.

Confirm nominal voltage, frequency, plug and socket type, earthing arrangement, breaker compatibility, and whether the venue uses single-phase or another supply configuration. The machine's approved input specification must match the destination supply; a travel adapter is not a substitute for correct electrical engineering. Export projects also need the buyer to identify the destination country, venue wiring standard, and any inspection process that applies locally. The supplier should provide the machine's electrical data, while the purchaser's electrician verifies the installation before energizing equipment.

Measure the narrowest point of every route, including the loading entrance, corridor, doorway, lift, ramp, turn, and final position. Compare those dimensions with the packaged and assembled machine dimensions, not only the advertised cabinet width. Note door swing, ceiling obstructions, floor transitions, stair limitations, lift capacity, and the equipment needed for movement. Packaging can increase width and height, while an assembled motorcycle cabinet may require a different turning path. Share photographs and a simple route drawing with the supplier before confirming shipment planning.

Plan three separate zones: the machine's physical envelope, the active player area around the motorcycle controls and seat, and a maintenance zone for opening panels or removing components. The riding position should not project into an aisle or conflict with another player's movement. Place units so staff can reach isolation points and service panels without moving unrelated equipment. Consider queue formation, sightlines, emergency circulation, cleaning, and cable protection. Validate the final arrangement against local accessibility, fire, occupancy, and electrical requirements rather than relying on a generic arcade spacing rule.